Wichita 10 Minute Water Heater Maintenance Check

Posted by on Feb 26, 2014 in Water Heater Repair Wichita

We are going to put you to work today, but only for about 10 minutes. Yep, that’s all it will take for these 2 important water heater maintenance jobs; however, Water Heater Repair Wichita understands they will do an outstanding job of assisting with three things:

  • Having your water heater last as long as possible (that will conserve you cash).
  • Making sure the water heater runs securely (we do not desire it to explode).
  • Having it run as energy efficiently as possible (also saving you money).

So with that in mind, are you all set to invest 10 minutes once or twice a year to assist in saving some cash? Water Heater Repair Wichita KS thought so.

Testing the T&P Relief Valve

Commonly called the T&P Valve, or the temperature and pressure relief valve, has a vital job. It helps see to it excess pressure does not build up inside the water storage tank, or in much more easy terms, it ensures the water heater does not explode. As the picture shows, it has a lever or little handle on it. All you have to do is raise it part way and then release it. Ideally, it snapped back to its shut position quickly. If it is working properly, a little water can be heard entering into the drain pipe below the lever you just raised and you possibly heard some pressure being released. If none of these things have actually taken place throughout the test, the valve will have to be changed.

As inspectapedia.com states: “dripping TP relief valves are unsafe. The hazard is that minerals in the water supply accumulate inside the valve during the passage of hot water through the valve assembly. That accumlation of scale will eventually block operation of the relief valve, causing the relief valve to fail to operate properly if unsafe pressure or temperature occurs in the water heater in the future. The risk, ultimately, is a water heater tank or heating boiler explosion.”  (read more…)

Carry out a Mimi Water Heater Tank Flush

By nature, rust and deterioration will take place inside the water storage tank thanks to the chemical reactions taking place with all the parts inside that are needed to warm the water. We will not get overly technical right here, however it is simple to assist avoid this from happening by doing a flush or draining of all or a portion of the water in the storage tank.

For simply a tiny flush, position a container under the drain valve below the tank. Open the drain valve and fill the bucket with water. Drain at least a couple of gallons of water in all. Let the water sit in the pail for a couple of minutes to settle and examine if there is much that settles to the bottom of the bucket. If there is, if the water heater has not been drained for a long time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will wish to turn the temperature level dial down and may wish to let the water cool down for about an hour initially so it is not too hot while draining it. Also, it would be simpler to connect a hose to the drain valve and let the water go outside instead of using containers.

If the water looks relatively clean and clear from the mini test you should be all set. When the water heater has a large amount of sediment inside of it, it can make loud popping sounds and it lowers its efficiency too.

Though water heaters are relatively upkeep free and easy to operate, any time you feel the smallest uncomfortable or are unsure of what to do, it is always best to have a plumbing professional assist with the situation.

 Water Heater Repair Wichita